Expert Answers about Chevrolet RV Step Covers

• Recommended RV Step Rug For A Step With A 13" Depth
• While we don't have a set of wraparound RV step rugs that are designed to fit a 13" depth, we do carry landing rugs like the Prest-O-Fit Interior RV Step Rug # PR55VR, which are 23-1/2" Wide x 13-1/2" Deep and come with a different mounting style. This rug has Velcro strips with an adhesive backing that would allow you to mount it to the step and you could just trim off any excess material that extends past the step.
  view full answer...


• Recommended Step Covers For A 2016 Airstream Flying Cloud 23FB
• The only step covers we currently offer are from Prest-O-Fit and would only wrap around just the step portion. These covers wrap around the step and tighten in place with springs for a custom fit for a variety of step depths and will allow the steps to extend or retract without any interference. The turf material is designed to take a lot of abuse and can be hosed off when dirty. The rubber backing will help cling to the surface of the steps so you don't have to worry about it slipping...
  view full answer...


• Can More Than One Safety Step Sand Away Dirt Trapping Step Cover Be Used
• While you can install a Safety Step Sand Away Dirt Trapping Step Cover # SASSA11-00 on each step, you can only leave it on the bottom step when the steps are closed. The middle step covers would need to be removed for the steps to retract. You could use the Safety Step Sand Away Dirt Trapping Step Cover # SASSA11-00 on the bottom step and then the Prest-O-Fit Wraparound Exterior RV Step Rug # PR57VR for your remaining steps. This should allow you to leave the step covers in place and still...
  view full answer...


• How To Know If Prest-O-Fit Step Rugs Will Fit Your MORryde StepAbove RV Steps
• The Prest-O-Fit 4-Piece Step Rug Set for MORryde StepAbove RV Steps # PR63SR are designed to fit 19-1/2" wide steps like the MORryde StepAbove RV Steps # MR88RR have. You'll just want to measure the width of your steps to confirm fitment. As for the depth, these covers are attached to the step using springs that can easily stretch to fit both your 10-1/2" and 8" depths.
  view full answer...


• Do Wraparound RV Step Rugs Fit The TorkLift GlowStep Revolution?
• Yes, you can absolutely use the Prest-O-Fit Wraparound Exterior RV Step Rug # PR22FR with your TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear # TLA8102. These wraparound exterior rugs fit straight steps that measure 20" wide and 11" to 8" deep. This is also available in -Light brown # PR42FR, -Green # PR92FR, -Blue # PR82FR, -Brown # PR72FR, & -Grey # PR54VR.
  view full answer...


• Front Mount Trailer Hitch Receiver For a 2006 Forest River Lexington 255DS E-450 RV Cutaway Chassis
• The Curt Front Mount Trailer Hitch Receiver # 33055 is confirmed to fit the Ford E-450 RV Cutaway chassis that is under your 2006 Forest River Lexington 255DS. I recommmend using either the etrailer Rubber Hitch Cover # 22282 or WeatherTech BumpStepXL Hitch-Mounted Bumper Protector and Step # WT81BS1XL to fill the receiver hole and eliminate the whistle it often creates. The step is great as it will give you that added reach when cleaning your RV.
  view full answer...


• Recommendation For Step Cover For RV And Camper Steps
• Safety Step Sand Away Dirt Trapping Step Cover, Item # SASSA08-00, was designed originally for motorized steps and you should not have any closing/fit problems with this product. While specifically designed for motorized steps, we have never had a closing issue with these on rectangular steps on motorized or manual models. Item # SASSA08-00 is designed to fit steps that are 22 inches long x 8-1/4 inches wide. It is an easy install and no tools are required-my favorite kind. Cleaning...
  view full answer...


• Solid Step Fold-Down Steps for RV Compatibility with Screen Door Bar
• The SolidStep Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames - Quad - Aluminum # LC791574 will work fine with most screen door bars like the Camco Deluxe RV Screen Door Cross Bar - 21-1/4" long to 28-5/8" long - Aluminum - Black # CAM42183 that sounds similar to your description. You won't have issue with the bar if it is just above the plastic bubble cover slide as you stated.
  view full answer...


• Tire Covers for 22.5" Diameter Tires on RV
• For 22.5" tires you'll need the next step up from the SnapRing TireSavers Tire Covers - 19" to 22" Diameter - Black Vinyl # ST7006BK. The Classic Accessories RV Wheel Covers # 052963762303 is what you will need. These are the only covers offered that fit a 21" - 24" diameter tire range so they will fit properly. While these don't have that snap ring-style to secure on the tire, they do have an elastic band that holds them tight against the tire so you don't have to worry about them getting...
  view full answer...


• Recommended Support Legs For A Manual Pull-Out RV Step
• What you're looking for doesn't really exist (yet) but there are options like the Lippert Solid Stance RV Step Support Kit # LC96BJ that you can add on to help support the step. I've attached a short video below going over how to install and use these supports.
  view full answer...


• Recommended Step Rugs For 22" Wide MORryde Flip Steps
• While we don't currently have step rugs specifically designed for your MORryde Flip Steps we do have universal step rugs like the Prest-O-Fit Outrigger 3-Piece Exterior RV Step Rug Set # PR72MR. The grommets on the bottom side of the rugs allow for you to tighten down the rugs to fit the size of your steps. It does unfortunately only come in either a 3-pack # PR72MR or 1-pack # PR49ZR, so you would have to order two separate packs to cover each of your 4 steps.
  view full answer...


• Will BAK Revolver X4s Fit 2024 Ford Maverick With Modular Hard Drop-In Bedliner
• Yes, the BAK Revolver X4s # BAK85RV can be installed on your 2024 Ford Maverick with the bedliner. You will need to follow the instructions for a drop-in bedliner when you install the cover. They also have a note that states "some drop-in bedliners may require trimming in the corners to fit the rail into the opening." under step two for the cover rail. I have attached an installation video below along with the written instructions for your reference.
  view full answer...


• Availability of 2 Bike Rack on 21 foot Big Foot Travel Trailer with RV Ladder
• For your 21 foot Big Foot Travel Trailer I recommend a Swagman RV bumper 2 Bike Rack, # S80605, if you have a 4 to 4-1/2 inch welded steel square bumper. After checking with Surco, The Ladder Mounted 2 Bike Carrier, # SP501BR, is 9-1/4 inches wide at the top which would fit the ladder on your trailer.
  view full answer...


• Can the ThermaHeat RV Holding Tank or Step Heater Pad Be Mounted Over a Strap?
• Yes, it can but ideally you would want to make as much contact as possible with the tank to get the most out of the heating pad. The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat item # 277-000164 would not get hot enough to damage the strap but it may allow dirt or debris to get inside any gaps or openings that covering the strap might create. Additionally the pad will automatically turn on at 45 degrees Fahrenheit and auto shuts off at 67 degrees Fahrenheit the strap may...
  view full answer...


• Does My Bike Fit on a Thule EasyFold XT, and Do You Have Any Covers for the EasyFold XT?
• I have a great solution for you. With a 3-inch wide tire on your Lectric XP 2.0 step-thru electric bikes, you will not need to purchase the Fat Bike Straps for Thule EasyFold XT Bike Rack # TH903202 for that tire width alone. The EasyFold XT will hold bike tires 3-inches or less. However, if the wheelbase of your bike is close to the maximum 51-3/16" long, I recommend purchasing the Fat Tire Straps # TH985101. This is because the longer straps will ensure that you have the extra length...
  view full answer...


• Lippert Ground Control TT Automatic Leveling Kit for 2020 Lance Travel Trailer
• It does not look like you will be able to use the Lippert Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System # LC672136 on your 2020 Lance 2285 travel trailer unless you switch your fold up rear steps to a set of fold in steps like the MORryde StepAbove RV Steps # MR78RR that will fit inside your door. This is due to the rear jacks needing to mount between 18" and 48" behind the bolt that holds the rear leaf spring on your camper. I have linked the installation...
  view full answer...


• Replacement Tail Light for a 2015 Forest River Rockwood 2703WS
• Yep, that is a RV Tail Light - Stop, Tail, Turn # RVSTB60. But to be extra sure we can look at the measurements. This light is 8-5/8 inches long and 3-3/16 inches tall with a depth of 2-1/4 inches. The mounting holes on the back are space 7-3/8 inches on center side to side and 1-7/8 inches on center top to bottom.
  view full answer...


• How Much Clearance is Needed on Each Side of a Slide-Out for a Slide-Out Awning
• It sounds like you are needing to get a slide-out awning for your RV, but that your awning arm could be an obstruction. In order to use a slide-out awning like the Solera RV Slide-Out Awning # LCV000165063, you will need at least 7" of clearance on both sides of your slide-out box. Since you do not have 7" of clearance, you will need to order the next size down in order to have the appropriate clearance. Measuring for the correct slide-out awning should be done by measure from the outside...
  view full answer...


• Will The Advent Air For Replacement For Carrier Air Be Compatible With A Carrier Air RV AC System
• Yes, the Advent Air Replacement RV Air Conditioner for Carrier Setup # ACCAR150 comes with a wiring harness adapter that's designed to work with Carrier Air units so you'll be able to remove your current rooftop unit and swap it out with this one and still utilize your air distribution box and thermostat. If you're doing this installation yourself you'll want to first remove the plenum (cover) on your air distribution box and see if the controller is located in the ceiling or up in the...
  view full answer...


• Does The Door Trim Have to Be Removed To Install SolidStep Lift Assist Kit RV Doors LC733939
• The mounting bracket of the SolidStep Lift Assist Kit for 30" to 36" RV Doors part # LC733939 basically installs 1/4" away from the door jamb on the interior wall. It does need to be flush with the door jamb so if there is a piece of door trim keeping the bracket from being level with the door jamb then it needs to be removed. The 1/4" measurement is from the installation instructions for the lift assist kit itself which I have sent you in a separate email. The 1/4” gap will allow the rotating...
  view full answer...